Layout And Items Supplied; Intended Use; Technical Data; Installation Material - Gardol GRW-E 57 Manual De Instrucciones

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Layout and items supplied

1.1 Layout (Fig. 1)
1 Roller
2 Dirt wiper
3 Bottom shaft
4 Push bar
1.2 Items supplied
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Original operating instructions
Anl_GRW_E_57_SPK7.indb 8 Anl_GRW_E_57_SPK7.indb 8
GB

2. Intended use

Lawn and garden roller for rolling surfaces and
freshly sown seed (for example grass seed but
also seed in beds) to ensure that the seed is per-
fectly inserted in the soil.
The roller can also be used after the lawn area
has been scarifi ed or fertilized.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Approx. roller width ....................................57 cm
Approx. roller diameter ...............................32 cm
Approx. volume ...................................... 46 liters
Approx. total height with push bar ............110 cm
Approx. max. weight fi lled with water ............57 kg
Weight unfi lled ............................................11 kg

4. Installation material

Fig. 2
5 Thread cover (2x)
6 Cap nut M8 (2x)
7 Nut M 8 self-locking (2x)
8 Sealing cap (1x)
9 Wing nut M5 (2x)
10 Lock bolt M5 (2x)
5. Assembly
Fig. 3-10
To assemble, you will require a SW 13 mm open-
ended wrench.
Follow Figures 3 – 10 for the assembly.
Once assembled, fi ll the roller with water, sand or
concrete.
- 8 -
10.09.15 15:08 10.09.15 15:08