Replacing Carbon Brushes - Makita 2704 Manual De Instrucciones

Lubrication
To keep the table saw in tip-top running condition, and to
assure maximum service life, oil or grease the moving
parts and rotating parts from time to time.
Lubrication places:
• Threaded shaft to elevate the blade
• Hinge to rotate the frame
• Elevation guide shafts on motor
• Gear to elevate the blade
• Guide rails for the rip fence
• Shaft of the sub table (R) locking levers
• Sliding part of the sub table (R)

Replacing carbon brushes

Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only
identical carbon brushes. (Fig. 47)
Use a screwdriver to remove the brush holder caps. To
replace the carbon brushes, remove the blade guard and
blade and then loosen the lock lever, tilt the saw head and
secure it at 45° bevel angle. Carefully lay the tool on itself
backward. Then loosen the brush holder cap. Remove the
worn carbon brushes, insert the new ones and secure the
brush holder caps. (Fig. 48)
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita service center.
• Table stand set (accessory)
Refer to the instruction manual for table saw stand that
is provided with the table saw stand as an optional
accessory.
• Steel & Carbide-tipped saw blades
• Sub table (L)
• Sub table (back)
• Rip fence
• Miter gauge
• Offset wrench 13 – 22
• Wrench 19
• Hex wrench 5
• Joint (for connecting to dust collector)
• Auxiliary plate
• Stand set
• Sliding guide
15