• The appliance's power network must be equipped with a suitable
omnipolar disconnection device compliant with national installation
regulations.
• The appliance is powered solely through a socket compatible with the plug provided.
CAUTION
Any replacement of the power cable must be carried out solely by Olimpia Splen-
did technical support or by similarly qualified personnel.
2.6 - DRAINAGE
Depending on the modality of use of the appliance, it is necessary to connect the condensation discharge pipe.
2.6.a - Use as dehumidifier
For the correct use of the appliance, work as follows (figures 29
and 32):
a. Remove the cap (28).
b. Insert the supplied pipe (12) in the connector.
Make sure the end of the discharge pipe (12) is positioned
on a drain well or in a container.
Make sure the pipe (12) is not clogged.
c. If necessary, apply the terminal (13) to the condensation dis-
charge pipe (12).
2.6.b - Use as heat pump
(only for the suitable version)
For the correct use of the appliance, work as follows (figures 30
and 33):
a. Remove the cap (35).
b. Insert the supplied pipe (12) in the connector.
Make sure the end of the discharge pipe (12) is positioned
on a drain well or in a container.
Make sure the pipe (12) is not clogged.
c. If necessary, apply the terminal (13) to the condensation dis-
charge pipe (12).
EN - 13
32
33
35
12
28
12