ESTEBAN Edition Art Instrucciones De Uso página 3

STARTING THE DIFFUSER
Read the below-mentionned instructions carefully before starting the diffuser.
STAGE 1
1
• Plug the appliance into a (mains) socket. Only use the electric plug intended for this purpose.
Check that the electric plug is in conformity with your country's electricity installation; If not,
add a universal adapter to the plug.
• In order to avoid any accident, make sure that the cable is not located in an area where people walk.
STAGE 2
2
• Remove the upper parts A and B. Pour water at room temperature into the container, by using
the graduated glass (C) DO NOT exceed the maximum level of
hot water into the container (risk of damage of sensitive components).
• Add a few drops of Estéban refresher oil or essential oils: at least 5, or more depending on the
expected intensity.
A
- Do not pour drops of refresher oil or essential oils into the container if
there is no water in it.
- Wipe up any drops that may accidentally have fallen outside the container.
- An excess of refresher oil or essential oils could prevent the diffusion and damage the diffuser.
• Place the upper parts B then A back on the diffuser base (D).
B
C
• Do not move the diffuser once you have fi lled it.
maximum
level 80ml
E
STAGE 3
D
• Press the ON / OFF button:
3
1st press, the blue light lights up dimly, diffusion starts and stops automatically after
30 min.
2nd press, the blue light lights up more intensely, diffusion starts and stops automatically
after 3 hours maximum for a maximum fi lling level (80 ml).
ON/OFF
3rd press, the blue light goes out, diffusion stops.
• Thanks to the automatic stop system, you can enjoy the perfumed atmosphere without
worrying about the diffuser.
• During the diffusion, the height of the mist may vary.
When the appliance is operating, make sure not to put any obstacle above the appliance that
could hamper the release of the mist and not to remove the upper parts in order to avoid any
splashing.
STAGE 4
• The appliance stops automatically if there is not enough water: the blue light fl ashes.
4
Unplug the appliance, then empty out the remaining water and clean it (refer to the cleaning
recommendations in the operation and maintenance instructions).
4
OPERATION AND MAINTENANCE INSTRUCTIONS
CLEANING
Clean the appliance after each use:
• always switch it off and unplug from the mains
• remove the two upper parts
• empty out the container of water by following the direction of the arrow placed on the bottom of the container to avoid any contact
with electrical parts
• in order to remove all residues, use absorbent paper impregnated with a mild detergent (soap, washing-up liquid,...
Do not use aerosol sprays, solvents or abrasive products) to clean the inside of the water container. Then wipe it with a dry cloth
• use a soft cloth with a little of water if necessary to clean the outside of the diffuser
• use a wet cotton bud to clean the ceramic disk
• as this disk is very fragile and sensitive, make sure not to press too strong and clean it after each use for longer operating life.
NEW USE
• See STAGE 2 of the section "starting the diffuser "
• replace the water in the container frequently to avoid any residue that might damage the diffuser
• for an optimum fragrance, empty out the liquid remaining after each use and clean the water container and its ceramic disk each time
80ml
. Do not pour
you change the water or fragrance.
LONG PERIOD WITHOUT USE
If the appliance is not going to be used during a long period, clean it, dry it (by following the instructions in section « cleaning »), and keep
it in a dry place.
REPAIR
If the product is not working properly, check the following points:
Problems
Symptoms
The blue light does not
work
No mist when the
appliance is switched on
Mist stops while the
diffuser is in operation
Insuffi cient mist
Should the problems persist please contact your retailer.
The manufacturer is not responsible for damages caused by improper use of the diffuser.
Causes
The appliance is not plugged in Make sure that the power adapter is properly connected
to the appliance and fully plugged in to the wall socket
Water level too low Fill the water reservoir
Water level exceeds 80 ml Empty out excess water
The ends of parts A and B are obstructed Make sure that nothing is preventing the release of the
mist
Water level too low Fill the water reservoir
Accumulation of water drops on the end of Switch off the diffuser, remove parts A and B then clean off
part B the accumulated water drops
Accumulation of water drops on the air Switch off the diffuser, remove parts A and B then clean off
outfl ow E (see plan on STAGE 2) the accumulated water drops
The ceramic disk is dirty Clean the ceramic disk as described in the "cleaning"
instructions
An excess of Estéban refresher oil or Empty the appliance and clean it
essential oils has been poured into the
container
Accumulation of water drops on the end of Switch off the appliance, remove parts A and B then clean
part B off the accumulated water drops
Solutions
5