Cleaning Instructions - Hamilton Beach Tango Serie Manual De Uso

840080600env03 10/24/01 10:07 AM Page 8
Caring for the Blender

Cleaning Instructions

wWARNING
Electrical Shock Hazard
Disconnect power before cleaning.
Replace all parts before operating.
Do not immerse base in water or
other liquid.
Failure to do so can result in death
or electrical shock.
General cleaning
The jar should be cleaned immediately
AFTER EACH USE. The jar can be
cleaned in the following manner:
1. Fill the jar half full with warm water,
122° F (50° C).
2. Add a drop of liquid detergent or
1 / teaspoon of detergent powder.
2
3. Place the cover/filler cap on the jar and
blend for 30 seconds.
4. Turn the blender off, and then rinse
the jar and wipe down to dry. Do not
disassemble the cutter assembly.
5. Wash the jar cover/filler cap in warm,
soapy water. Rinse and let dry.
6. Unplug the blender.
7. Wipe down the blender base with a
damp cloth.
8
wWARNING
Cut Hazard
Always place cover on container
before operating blender.
Do not put spoon or other utensils
in jar when blending.
Failure to follow these instructions
can result in broken bones, cuts, or
other injuries.
Sanitizing
If the blender will not be used again
within 1 hour, sanitize the container
in the following manner:
1. After washing the jar, fill it with a cold
chlorine-based sanitizing solution that
has a minimum chlorine concentration
of 100 parts per million.
See recommended solution below.
2. Place the cover/filler cap on the jar and
blend for a minimum of 2 minutes.
3. Empty the jar but do not rinse.
4. Dry the jar by placing it with its
cover on the blender base and turn the
blender On for 2 seconds.
5. Immerse the cover and filler cap in
sanitizing solution for 2 minutes.
Recommended Sanitizing Solution:
The sanitizing solution should consist of
1 tablespoon of household bleach per 1
gallon of clean, cool water (60° F, 16° C)
mixed according to the instructions on
the bleach. When using a sanitizing
solution other than that recommended,
the sanitizing solution concentration
should be tested using commercially
available test strips and should indicate a
concentration between 100 and 200 parts
per million of bleach to water.