Operation; Switching On; Recommended Settings - Silvercrest SIKP 2000 C1 Instrucciones De Servicio

BB&3(B,QGXNWLRQVNRFKSODWWHB%ERRN 6HLWH  'LHQVWDJ  $SULO    

9. Operation

DANGER! Risk of fire!
~ Heat oil and fat carefully. Overheated
oil and fat is flammable. Do not leave
hot oil or fat unattended.
~ DANGER OF EXPLOSION! Never
extinguish burning oil or fat with water.
Smother the flames by closing the cook-
ing vessel with a suitable lid or plate.
Pull out the mains plug.
DANGER! Risk of injury
through burning!
~ Do not touch the surface of an induction
hot plate, on which a cooking vessel
has been used beforehand. The temper-
ature of the surface can still be very
high after a cooking vessel has been re-
moved.

9.1 Switching on

1. Place the cooking vessel in the middle
of the cooking zone|2.
2. Insert the mains plug|1 into a wall sock-
et corresponding to the specifications of
the rating plate. An acoustic signal
sounds. At the same time, the display
and control lights are activated shortly
so they can be checked for proper func-
tioning.
The display shows...
... - L -, if the temperature of the cooking
zone is less than 60 °C and
... - H -, if the temperature of the cook-
ing zone is more than 60 °C.
3. Switch on the appliance by touching the
symbol on/off |5.
The control light on/off|4 lights up.
W (watt) lights up over the display, and
on the display you can see the chosen
power setting (preset when switching
on: 0 watt).
44 GB
NOTE: if you do not initiate any changes
within approx. 30 seconds by touching the
symbols |7/ |8, the appliance switches
off automatically.
4. Change the heat output in steps of
200 watts by touching the symbol
- |7 from 200 - 2000 watts
or the symbol
- |8 from 2000 to 200 watt.
The heating phase begins immediately
after you have touched one of the two
symbols. The higher the chosen power,
the quicker the base of the cooking ves-
sel is heated up. You can also hold down
buttons |7/ |8; the watt output will
then change faster.
5. By touching the symbols
play image changes from W (watt)
to|°C. You can now choose the desired
setting also as a temperature specifica-
tion in steps of 20 °C from 60 - 240 °C
(presetting: 120 °C). After the tempera-
ture has been achieved, it is kept at the
specified value.
You can change specified settings at
any time during operation.
You can also touch the symbols uninter-
ruptedly to change the settings.

9.2 Recommended settings

NOTE: if you fry with too high an output
(number of watts), the device may overheat.
The error message E7 appears. Switch off
the device and let it cool down. Then contin-
ue to fry using a maximum of 1000 watts.
Cooking: 200 - 2000 watt
Frying: 200 - 1000 watt
|10, the dis-