Troubleshooting; Tips For Energy Saving - Technibel CA 250 X5 TA Instrucciones De Uso

If your air conditioner does not work properly, first check the following points before requesting service.
If it still does not work properly, contact your dealer or service center.
Trouble
Air conditioner does not
run at all.
Compressor runs but
soon stops.
Poor cooling
performance.
Do not
NOTE

Troubleshooting

Possible Cause
1. Power failure.
2. Leakage breaker tripped.
3. Line voltage is too low.
4. ON/OFF operation button is OFF.
5. Batteries in remote control unit
have run down.
1. Obstruction in front of condenser
coil.
1. Dirty or clogged air filter.
2. Heat source (cooker, heater, or
electrical appliance) or many
people in room.
3. Doors and/or windows are open.
4. Obstacle near air intake or air
discharge port.
5. Thermostat is set too high.

Tips for Energy Saving

Block the air intake and outlet of the unit. If either is obstructed, the
•
unit will not work well, and may be damaged.
Let direct sunlight into the room. Use sunshades, blinds or curtains.
•
If the walls and ceiling of the room are warmed by the sun, it will
take longer to cool the room.
Do Always try to keep the air filter clean. (Refer to ''Care and Cleaning.'')
•
A clogged filter will impair the performance of the unit.
To prevent conditioned air from escaping, keep windows, doors and
•
any other openings closed.
Should the power fail while the unit is running
If the power supply for this unit is temporarily interrupted the unit will
automatically resume operation (once the power is restored) with the
same settings that were in effect before the power was interrupted.
Remedy
1. Restore power.
2. Contact service center.
3. Consult with electrician or dealer.
4. Press the button again.
5. Replace batteries.
1. Remove obstruction.
1. Clean the air filter to improve the
air flow.
2. Eliminate heat source if possible.
3. Shut them to keep the heat out.
4. Remove it to ensure good air flow.
5. Set the temperature lower.
21