Interaction With Batteries; Connecting The Loudspeaker; Additional Audio Device; Preparing The Antenna Reception - Silvercrest KH2306 Instrucciones De Uso

Interaction with batteries

Leaking batteries can cause damage to the
device.
• If you do not intend to use the device for an
extended period, remove the batteries.
• Always change all batteries at the same time
and always use batteries of the same type.
• Should the batteries leak, wear protective
gloves and clean the battery compartment
with a dry cloth.

Connecting the loudspeaker

Important!
Prior to connecting the speakers, please ensure the
Micro System is turned off.
Do not plug the Micro System into the mains power
until all connections have been made.
1. Connect the speaker cable of the Micro System's
right loudspeaker by plugging it into the double
jack marked "R".
Please ensure to connect the black wire to the black
negative jack and the red wire to the red positive
jacks.
Keep the clamp of the respective speaker jack
depressed while inserting the wire.
2. Connect the speaker cable of the Micro System's
left loudspeaker by plugging it into the double
jack marked "L". Conntinue by following the
same procedure as explained for the right
loudspeaker.

Additional audio device

You can connect additional audio devices, e.g., a
television, to the Micro System for playback over
the Micro System.
• Connect the stereo plug of the audio device with
the jack AUX IN at the front of the Micro System.

Preparing the antenna reception

For receiving AM transmissions, there is an in-built
reception antenna. In radio operation, turn the whole
appliance to a position where the best radio recep-
tion is obtained.
For receiving FM transmissions, the Micro System is
equipped with a small wire aerial in the back of the
unit.
• In order to ensure excellent reception with your
Micro System, carefully pull out the wire aerial
completely.
Note:
Should FM radio reception be inadequate, change
the position of the wire antenna.

Connecting the Headset

You can connect stereo headphones to the Micro
System with a 3.5 mm jack plug. The jacks for the
PHONES
headset are located at the front of the Micro
System. When headphones are connected, the loud-
speakers are switched off and you will only hear
sound via the headphones.
• Insert the jack plug on the headset into the
headset socket.
Warning:
Listening to music with headset for long
periods and at high volume levels can
lead to hearing damage!

Power supply

• When all of the required connections have been
made, insert the plug on the power cable into a
wall power socket. The device is now in standby
mode and the green stand-by LED is illuminated.
While in standby mode, the time is displayed. If the
time has not been set yet, the display will show: 0:00.
In order to set the time, please read the following
instructions.
- 34 -