Setting The Time; Utilisation; Switching The Device On And Off; Adjusting The Volume - Silvercrest KH2306 Instrucciones De Uso

Setting the time

1. While in standby mode, depress the button
SET
for more than two seconds.
The time display will start to flash.
2. Within the next 10 seconds use the pushbutton
BACK NEXT
and ( and
to set the time in either 24-hour or 12-hour mode.
In the 12-hour mode the morning hours are displayed
as AM.
3. Press the pushbutton
this setting.
The hour-display now blinks.
4. Within the next 10 seconds use the pushbutton
BACK NEXT
and ( and
to set the hour of the day.
5. Press the pushbutton
this setting.
The minute-display now blinks.
6. Within the next 10 seconds use the pushbutton
BACK NEXT
and ( and
to set the minutes.
7. Press the pushbutton
this setting. The time display is now programmed.
In order to ensure a continuous display of the clock,
even after a power failure or after the mains cable
has been removed, please insert the back-up batteries.

Utilisation

Operating the pushbuttons on the
device and on the remote control
Most functions can be activated by pushing the
buttons on the device itself or on the remote control.
These instructions only describe the pushbuttons of
the device. Any reference to the pushbuttons on the
remote control will be specifically highlighted.

Switching the device on and off

• To turn the Micro System on, please push the
STANDBY
button, either on the device itself or on
the remote control unit.
CLOCK
on the remote control)
CLOCK SET
to acknowledge
on the remote control)
CLOCK SET
to acknowledge
on the remote control)
CLOCK SET
to acknowledge
The green standby LED extinguishes and the display
is being illuminated.
• To switch the device back into the standby
mode, press the button
• If you would like to completely shut off the device,
remove the power cable from the mains.

Adjusting the volume.

• In order to increase the volume, press the pushbutton
VOL. UP
on the device (
unit).
• Press the pushbutton
the remote control), in order to reduce the volume.
Switching off the sound
• To switch the sound completely off, press the
MUTE
button on the remote control.
• To turn the sound back on, press the button
again or press the the button
on the remote control).

Selecting the sound source

After you turned on the device, use the button
CD/MP3 AUX RADIO
, or
would like to play back:
CD/MP3
:
AUX
:
RADIO
:

Radio functions

• Set the reception range (AM/FM) by using the
BAND
button . The respective reception range
together with the frequency will be displayed
for approximately 5 seconds. Subsequently,
the time is displayed again.
• In order to switch between frequency and time
display press the pushbutton

Setting the radio frequency

1. Set the desired radio station by rotating the
tuning knob. The frequency will be shown in
the display.
- 35 -
STANDBY
again.
VOL+
on the remote control
VOL. DN
on the device (
VOL. UP/VOL. DN
to select the sound source you
Audio-/MP3-Disc playback
External sound source
Radio operation
DISPLAY
.
VOL-
on
MUTE
VOL+/-
(