Assembling And Connecting The Heater Kit - Eneo VHM-Z Serie Instrucciones De Manejo

6. Assembling and connecting the heater kit

6.1 Assembling the VHM/H24W 24V heater kit (Art. No. 71602)
Note: The VHM/H24W heater kit is premounted at VHM-ZLB-W and VHM-ZLKCB-W.
A
S
F, A Front panel,
housing centre
section
H
Heater plate
f, r Screws,
spacer pins
S
Cable duct
r
f
Unscrew the front section F (with the glass pane) from housing centre section A.
Screw heater plate H onto front section F. The resistors must face the glass insert.
To do this, use the screws f and spacer pins r (8mm) from the pack supplied as shown
on the diagram.
Feed the power supply connection from the heater plate through cable duct S and
connect it to the terminal board in the rear section of the housing.
F
r
H
0