Qlima D 416 Instrucciones De Uso página 58

• Pressing + button will increase humidity while pressing - button will decrease
humidity. The display range of humidity is 35%~80%. Each pressing will increase/
decrease humidity by 5%.
• Continuous Dehumidify Setting: This function can be set by pressing CONTINUOUS
button.
[Attention] : When selecting CO mode, drain hose has to be installed, Otherwise,
• When setting Timer On or Timer Off, press these buttons to adjust time.
For specific details, please refer to Timer Button description below.
• When unit is in operation, holding + and - button simultaneously for 3s can lock
buttons. If this function is turned on, Button Locked Indicator will be on and
display window shows LC, which will blink for 3 times. Then ambient humidity is
displayed again. To turn off this function, hold + and - button simultaneously for
3s and the indicator will be off.
FAN SPEED Button
3
Pressing this button can set fan speed circularly as: High, Medium, Low.
Corresponding indicator will be on for each fan speed.
TIMER Button
4
Press this button to set Timer On or Timer Off (Timing range 0.5~24h).
• Set Timer Off:
When unit is on, press this button and the Timer Indicator will blink while display
window will show the timing figure. Pressing + or - button each time will increase
or decrease the time by 0.5h or 1h (When figure varies within 10h, pressing +/-
button will increase/decrease the time by 0.5h; when figure varies from 10h to 24h,
pressing +/- button will increase / decrease the time by 1h). When time is set, wait
for 5s or press this button to turn this function on. Timing Indicator will be on.
• Cancel Timer Off:
Under the condition that this function is turned on, press this button to cancel it.
Timing Indicator will be off.
• Set Timer On:
When unit is off, press this button and the Timer Indicator will be blink while
display window will show the timing figure. Pressing + or - button each time will
increase or decrease the time by 0.5h or 1h (When figure varies within 10h, pressing
+/- button will increase/decrease the time by 0.5h; when figure varies from 10h to
24h, pressing +/- button will increase / decrease the time by 1h). When time is set,
wait for 5s or press this button to turn this function on. Timing Indicator will be on.
• Cancel Timer On:
Under the condition that this function is turned on, press this button to cancel it.
Timing Indicator will be off.
• Timing range: 0.5~24 hours
MODE button
5
Press this button to select different kinds of working mode. After each pressing
of this button, mode will switch among free drying, sleeping space, living space,
basement and continuous drying modes, and the corresponding mode indicator will
ON. When free drying, all mode indicators are OFF.
CONTINUOUS Button
6
When continuous dehumidification mode is selected, the corresponding continuous
dehumidify indicator will be on,the dehumidifier will operate continuously at
its maximum dehumidification settings if attached to a hose to drain or until the
4
bucket is full.
58 58
unit will stop when water bucket is full.