Descargar Imprimir esta página

Orbegozo SF 3345 Manual De Instrucciones página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

SF 3345
15. Base
16. Weight
17. Fastener
18. Locking screw
ASSEMBLY:
1.
Take the base and tube parts from the packing box and loose the 4 joint screws. Fix the tube on the
base plate by the joint screws
2.
Place the motor over the tube using the knob
3.
Remove the parts from the packing. Separate the front and rear guard if they are connected.
4.
Remove the four position screws on the motor, offer up and align the rear guard with the four holes on
the motor (handle to top of the fan) insert the four position screws and tighten.
5.
Loosen the set screw on the blade, slide the blade into the shaft of the motor, tighten the set screw
onto the flat of the shaft to secure the blade. Ensure that the blade does not foul the guards.
6.
Assemble the front guard to the rear guard. Tighten the screw and nut,
CLEANING INSTRUCTIONS
1.
Be sure to unplug the fan from electrical supply source before cleaning.
2.
Plastic parts should be cleaned with mild soap and a damp cloth or sponge. Thoroughly remove soap
film with clean water.
3.
To disassemble each part, reverse the order of assembly.
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal
unsorted municipal waste stream. Old appliances must be collected separately in order to
optimize the recovery and recycling of the materials they contain, and reduce the impact on
human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal of
their old appliance.
DECLARATION OF CONFORMITY:
This device complies with the requirements of the Low Voltage Directive 2006/95/EC and the
requirements of the EMC directive 2004/108/EC.
secure the retaining clips.
10

Publicidad

loading