IKAR HRA height safety device with rescue hoisting facility as a
component:
The IKAR HRA height safety device with rescue hoisting facility is affixed
using the mounting bracket on the leg that is fastened on the type label.
For this, mount the mounting bracket (, and ) on the leg so that
the safety monitor can operate the rescue crank ergonomically and
comfortably in the event of a rescue. The correct clamping tension of the
mounting bracket is attained by the length (45.8 mm) of the spacer sleeves
supplied. The tightening torque of the hexagon socket bolts of quality class
8.8 M10x75 is 49 Nm. The safety bar should be positioned in line with the
device size. The tightening torque of the cylinder head screws of quality
class 8.8 M8x40 is 20 Nm.
Insert the IKAR HRA device into the mounting bracket. The IKAR HRA
device is secured using safety bolts
Oben
Caution: Only use IKAR mounting brackets.
Only IKAR equipment should be attached with IKAR mounting brackets.
9
Deflection roller with snap hook:
The deflection roller serves to guide and deflect the steel rope of the
IKAR HRA height safety device. Open the closed
deflection roller () by twisting the two plates and insert the steel
rope into the guide groove. Then twist the two plates back. Clip
snap hook to deflection roller and fasten to the anchorage point of
the tripod.
Caution:
Only use snap hooks made from steel in compliance with EN 362
Class B.
Tighten the screw lock on the snap hook.
Check pulley for ease of movement
ENGLISH
Preparing readiness for use
IKAR tripod
Oben
Spacer sleeve
M 10x75
Item HRA 9.5 / 12
Item HRA 15 / 18
Item HRA 24 / 33 / 42
Safety bar
Please note:
The IKAR HRA device retracts the rope automatically,
unless the rescue hoist function is engaged.
M 8x40
10
Umlenkrolle / Deflection roller
max. Belastung: / max. load:
23
7
Top
8
Close
0299
1 Person
Bestandteil
Bestandteil
Dreibaum DB - A 1 / 2
Dreibaum DB - A 1 / 2
Baujahr :
05/2007
Baujahr :
05/2007
Fabrik-Nr.: 123456
Fabrik-Nr.: 123458
IKAR GmbH
D 36041 Fulda
Open