Use - Casselin CCF1 Manual De Instrucciones

WARNING
By operating the apparatus may reach high temperatures. To avoid burns and accidents, do not use
the machine malfunction and do not use spare parts that do not origins.
ELECTRICAL HAZARD
Risk from electrical current!
In case of improper installation, the device can be dangerous and cause injury. Before installation, check the
power system data. Connect the device only when there is compliance. The unit should be unpacked and
checked fully before connecting by a professional.

5.2 Use

WARNING
The establishment of the installation of the device and maintenance must be performed only by professionals.
• Do not leave the unit without monitor.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
COMMISSIONING
The unit must be completely removed from its packaging. All guards must be fully
withdrawn.
Place the machine upright on a solid, flat surface. Never put the unit on a flammable surface.
Do not install this device near open fires or other heating appliances.
It is prohibited to place on the device or in the distance less than 10 cm of the device flammable objects.
The safety distances for flammable materials according to their degree of flammability:
A nonflammable granite, sandstone, concrete, brick, ceramic tile, coating.
B flammability acumin, jefferson, lihnos, itaver
C1 poorly flammable wood Hardwoods trees, against-plated, hardened paper umakart
C2 average flammability chipboard solodur, cork, rubber, coatings
C3 easy flammability of wood fiber boards, polystyrene, plyurethène, PVC
The electric cable must be protected at least 16 amperes.
The device must be plugged directly into a wall outlet.
Using a power strip will crack up the device.
USE
Plugging in, press the ON / OFF switch: lights orange indicator and the resistance begins to heat
Set the machine using the thermostat knob to the desired temperature: the green LED lights up.
The green light goes off when the desired temperature is reached, the thermostat switches on again as
soon as the temperature drops.
To switch off set the temperature control to "0".
Always unplug the device when the device is not used.
The emptying of the bin can be made only when the device is unplugged and cooled. Use a suitable
container to the drain pipe, lift safety drain up and operate the lever to the specified item "open tap".
NOTE
The device has a security system in case of overheating. Upon activation, disconnect the device and allow it
to cool. If this protection system will start regularly, it is imperative to contact your dealer.
After automatic shutdown, the unit may be commissioned only by pressing the reset button on the unit's back
for this, wait until the temperature drops, press the Reset button.
EN