Storing Channels In Memory (Auto Memory) - JVC KV-C10 Manual De Instrucciones

Storing channels in memory (Auto memory)

The auto memory function picks up the TV broadcast signals in the area where you are and
stores them automatically in memory.
DOWN UP
KV-M700 color monitor
1
Monitor Remote
H/P
VOL
MODE
2
Monitor Remote
A.MEMO
AUTO/MANU
When scanning is over, the screen shows the TV program of the smallest channel number in
memory.
Notes:
• TV stations with weak signals are not be picked up, therefore not being stored in memory.
• If you drive from one broadcasting area to another, the stored channels will not be tuned in. In this
case, perform the auto memory function again to store the stations in another area.
2 1
AUTO/MANU MODE POWER
Select TV as the input source.
Press the MODE button on the monitor or the remote
CH
controller repeatedly to select TV.
MODE
H/P
VOL
CH
Start scanning TV broadcast signals.
Press and hold the AUTO/MANU button on the monitor or
press the A.MEMO button on the remote controller.
The auto memory function starts and TV broadcast signals
are picked up and stored in memory while scanning.
1
2
TV
VIDEO 1
SCAN
AUTO MEMORY
MONI
CH
MODE
H/P H/P
VOL VOL
CH
COLOR CONTRA
BRIGHT
VCR
KV-M700 remote
controller
SKIP
A.MEMO CALL
VIDEO 2
22
11