Electric Brake - Makita BTP130 Manual De Instrucciones

Electric brake

This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after switch trigger
release, have tool serviced at a Makita service center.
Lighting up the front lamp
1
007156
CAUTION:
Do not look in the light or see the source of light
•
directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The light automatically goes out 10 - 15 seconds after the
switch trigger is released.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
Reversing switch action
A
1
007157
This tool has a reversing switch to change the direction of
rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for
counterclockwise rotation.
When the reversing switch lever is in the neutral position,
the switch trigger cannot be pulled.
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the
•
reversing switch lever to the neutral position.
1. Lamp
1. Reversing switch
lever
B
Selecting the action mode
This tool employs an action mode changing lever. Select
one of the four modes suitable for your work needs by
using this lever.
For rotation with impact, turn the lever so that the arrow
on the lever points toward the
1
007158
For rotation with hammering, turn the lever so that the
arrow points toward the
007159
For rotation with clutch, turn the lever so that the arrow
points toward the
007160
For rotation only, turn the lever so that the arrow on the
lever points toward the
tool body.
1
007161
Sliding to the mark is high rotation and the
is low rotation.
6
mark on the tool body.
1. Action mode
changing lever
mark on the tool body.
1. Action mode
changing lever
1
mark on the tool body.
1. Action mode
changing lever
1
mark or the mark on the
1. Action mode
changing lever
mark