Electric Brake - Makita XDT09 Manual De Instrucciones

NOTE:
The tool automatically stops if you keep pulling the
•
switch trigger for about 180 seconds.

Electric brake

This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after the switch trigger
is released, have the tool serviced at a Makita service
center.
Lighting up the front lamp
CAUTION:
Do not look in the light or see the source of light
•
directly.
1
014965
014966
To turn on the lamp status, press the button
seconds. To turn off the lamp status, press the button
for few seconds again.
With the lamp status ON, pull the switch trigger to turn
on the lamp. To turn off, release it. The lamp goes out
approximately 10 seconds after releasing the switch
trigger.
With the lamp status OFF, the lamp will not turn on even
if the trigger is pulled.
NOTE:
To confirm the lamp status, pull the trigger. When
•
the lamp lights up by pulling the switch trigger, the
lamp status is ON. When the lamp does not come
on, the lamp status is OFF.
While pulling the switch trigger, the lamp status
•
cannot be changed.
For approximately 10 seconds after releasing the
•
switch trigger, the lamp status can be changed.
1. Lamp
1. Button
1
for few
Reversing switch action
1
A
014967
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for
counterclockwise rotation.
When the reversing switch lever is in the neutral
position, the switch trigger cannot be pulled.
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the
•
reversing switch lever to the neutral position.
Changing the impact force
2
3
4
5
1. Changed in four steps
2. Hard
3. Medium
4. Soft
5. T mode
6. Button
012609
6
1. Reversing
switch lever
1
B
1
6