Safety Instructions - Velleman VTSSC40N Manual Del Usuario

VTSSC40N – SOLDERING STATION WITH LCD & CERAMIC HEATER
1. Introduction + Description
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the VTSSC40N! Please read the manual carefully before bringing this device into service. This
soldering station features a temperature control (150°C to 450°C) and a digital temperature display which displays the set
temperature and the actual temperature simultaneously.
The VTSSC40N is a 48W soldering station with a temperature sensor in the ceramic heating element. The heating
element is supplied with the necessary power via a safe 24V transformer, while the bit is completely isolated from the
mains. In case of malfunction, a warning will be displayed on the LCD and the device will emit a sound.
Standard bit
Replacement soldering iron: VTSSC40N/SP
Spare bit
Dimensions
Weight
Environmental conditions

2. Safety Instructions

• Incorrect use of this tool may cause fire.
• Be cautious when using this tool in places where inflammable products are stored.
• Heat can cause fire to inflammable products even when they are not in sight.
• Do not use the tool in an explosive atmosphere.
• Place the tool back in its stand in order to let it cool down before storage.
3. Operating Instructions
• Verify whether the mains voltage is compatible with the operating voltage of the device before plugging it in.
• Make sure that the device was not damaged in transit.
• Connect the soldering iron by means of the 4-pin plug and screw its nut tightly.
• Switch the device on by means of the on/off switch and set the desired temperature by means of the pushbuttons.
One brief push will result in a 1° modification ; keep the button pushed to modify faster (steps of 10°).
VTSSC40N_v2
BITC10N1
BITC10N2, BITC10N3, BITC10N4
185 x 100 x 170mm
1.58kg.
+5><+40°C ; RH<85%
Referencia Electrónica Embajadores:
1. LCD temperature read-out (display precision: 5%)
2. temperature control
3. iron stand
4. soldering iron
5. sponge tray
6. soldering iron connection
7. ON/OFF switch
at the rear: fuse holder (250V/1A 5x20mm: FF1N)
- 3 -
HRJA040
VELLEMAN