Fitting Instructions - Brink 2555 Instrucciones De Montaje

Idiomas disponibles

Couplings class

Approval number

D- Value

Max. trailers dimensions

Max. vertical load

FITTING INSTRUCTIONS:

1. Position support A on the inside of the left chassis and fix at point B with

one M10 x 35 bolts with double washers, spring washers and nut, tigh-

ten finger-tight. Fit one M10 x 35 bolt with double washer, spring was-

hers and nuts, tighten finger-tight.

2. Position the supports D and E on the outside and inside, respectively, of

the right chassis. Fit two M10 x 35 bolts with washers, spring washers

and nuts at points F. Tighten finger-tight.

3. Position the towbar and fix to supports A, D and E as shown in the

sketch, using four M10 x 35 bolts with washers, spring washers and

nuts.

4. The ball hitch is fitted to the towbar with two M12 x 65 bolts with was-

hers and self-locking nuts. First tighten the bolts at points D and E and

then do the same for the other bolts as shown in the table.

: A 50-X

: e11 00-0728

: 6,2 kN

: 1200 kg

: 75 kg

NOTE:

* Remove the insulating material from the contact area of the fitting points.

* All bolts are quality 8.8 - nuts 8. or when mentioned in fitting instructions

10.9 / 10.

* Don't forget the spring- and plain washers.

* Consult your dealer for the maximum tolerated pull weight and ball

hitch pressure of your vehicle.

* It is recommendable to retighten all fixing bolts and nuts after the towbar

has been in use for some 1000 km/600 miles.

* Do not drill through brake-or fuellines.

* Remove (if present) the plastic caps from the spot welding nuts.

Torque settings for nuts and bolts (8.8):

M10

46 Nm

M12

71 Nm (with self locking bolts)