Installation - KitchenAid KHCMF 45000 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 43

Installation

! Before operating your new appliance please read
this instruction booklet carefully. It contains important
information for safe use, installation and care of the
appliance.
! Please keep these operating instructions for future
reference. Pass them on to possible new owners of the
appliance.
Positioning
! Keep packaging material out of the reach of children.
It can become a choking or suffocation hazard (see
Precautions and tips).
! The appliance must be installed by a qualified professional
according to the instructions provided. Incorrect installation
may cause harm to people and animals or may damage
property.
Built-in appliance
Use an appropriate cabinet to ensure that the appliance
operates properly.
• the supporting surface must be heat-resistant up to a
temperature of approximately 100°C.
• avoid installing the hob above a dishwasher: if this
cannot be avoided, place a waterproof separation
device between the two appliances.
• depending on the hob you want to install (see figure),
the cabinet must have the following dimensions:
Installing semi-flush hobs (KHCMS 45000)
All the necessary precautions must be taken in order to
install the appliance in conformity with current accident-
prevention regulations (CEI-UNI-CIG) relating to gas and
electrical connections. To ensure sit-on hobs installed in
kitchen cabinets operate correctly, the minimum distances
indicated should be observed (see figure). All adjacent
surfaces and the back panel should also be able to
withstand an overheating temperature of 65°C.
Securing the appliance to the cabinet
The appliance must be installed on a perfectly level
supporting surface.
Any deformities caused by improper fixing could affect the
features and operation of the hob.
• Before fitting the hob to the worktop, position the seal
provided along the perimeter of the hob, as illustrated
in the figure.
241
• The installation cavity should have the dimensions
indicated in the figure accompanying the previous
paragraph.
261
Fix the hob as follows:
1. Use the screws supplied to fit the 4 alignment springs
in the holes provided at the central point of each side of
the part underneath the hob.
2. Place the hob in the cavity, make sure it is in a central
position and push down on the whole perimeter until the
GB
700 min
50 min
27

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Khcms 45000

Tabla de contenido