Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
Do not hold the equipment by the mains cable when carrying it do not use then cable as a handle.
•
Keep the mains cable away from hot surfaces.
•
Make sure that the mains cable is not twisted or kinked when stored.
•
Never insert or allow any objects to fall into the openings of the equipment.
•
Never use the equipment where aerosol (spray) products are being used or where oxygen is released.
•
To protect against injuries, never use the equipment if the cutting set is damaged.
•
The equipment is safety-insulated and radio-screened.
Save these instructions!
Using for the first time
•
Oil the cutting set (Fig.5).
•
Connect to the mains.
•
Switch the equipment on using the On/Off switch (Fig. 1a) and, after use, switch it off again (Fig. 1b).
•
Note: The audible click that can sometimes be heard when switching the equipment on is a result of the
drive unit switching on. This is completely normal. A slight warming of the equipment and vibrations
during use are also completely normal.
Setting the power
The blade track is set at the optimum setting ex-factory. However, the blade track can change as a result of
voltage fluctuations. In the event of undervoltage, the blade track can shorten and, in the event of overvol-
tage, it can lengthen. If necessary, by changing the setting of the adjusting screw, you can set this blade track
yourself. To do so, use a screwdriver or a thin coin. .
•
Using the on/off switch, switch the equipment on (Fig. 1a).
•
Turn the adjusting screw clockwise until you hear a loud noise (Fig. 2b).
•
Then turn the adjusting screw anti-clockwise until the loud noise stops (Fig. 2a).
Cutting-length adjustment
With the adjustment lever at the side, the cutting length can be steplessly adjusted, even during operation.
•
Lift the adjustment lever upwards - minimum cutting length (Fig. 3a).
•
Lower the adjustment lever - maximum cutting length (Fig. 3b).
Cutting with attachment combs (depending on model)
Depending on the desired haircut, the equipment can be operated with or without attachment combs. To
this end, the cutting length adjustment lever has to be raised (Fig. 3a). Depending on the model, attachment
combs #1 (3 mm), #2 (6 mm), #3 (10 mm), #4 (13 mm) are included in the scope of the supply.
Attaching/Removing the attachment combs
•
Place the attachment comb onto the cutting edge of the cutting set and press it down onto the cutting set
in the direction of the housing until it clicks into position (Fig. 4a).
•
The attachment comb can easily be removed by lifting the hook in the direction of the arrow (Fig. 4b).
Clipper Set TR1000 · Operating instructions
#23880
7
Publicidad
Tabla de contenido
