Intended Use; Using The Awning; Cleaning And Maintenance - Dometic Ace AIR Instrucciones De Uso

Intended use

This awning is suitable for:
• motorhomes and caravans
• light to moderate weather
• touring
This awning is not suitable for:
• very strong winds or snowfall
• seasonal pitch* or commercial use
* All-Season models have been designed for use on seasonal pitches.
This product is only suitable for the intended purpose and application in
accordance with this instruction. Any other use, deviating from the
intended use, is not allowed! Dometic accepts no liability for any loss,
damage or injury incurred, directly or indirectly due to other as the
intended use.

Using the awning

!
CAUTION! Risk of injury and material damage
Never open the zipper on the protective sleeve while an air
pole is inflated. This will result in the air pole bursting.
Before first use
Familiarize yourself with the product by carrying out a test set up before
the product is used for the first time. Check if the scope of delivery is
complete.
Choosing a campsite
Choose a flat site that is protected from wind:
1. If necessary, use a windbreak.
2. Choose a shaded site to avoid UV degradation of the fabric.
3. Avoid pitching under trees as falling branches, resin, etc. can damage
the product.
4. Clear the site of sharp stones and debris to avoid damaging the
groundsheet.
5. Set up the product with the doors facing away from the wind.
Setting up the awning
!
CAUTION! Risk of injury and material damage
• Do not use any type of compressor designed to inflate
car tires.
• Only inflate the air poles into the green zone of the
pressure gauge of the supplied hand pump
(9 psi/0.62 bar).
A
NOTICE! Material damage
• Do not open or close the zippers by force.
• If a wind-out awning is used to attach the awning,
support the wind-out awning while working to avoid
putting too much stress on it. After attaching the
awning, rewind the wind-out awning fully back into its
housing.
I
NOTE
• The awning comes with heavy duty pegs. These will be
suitable for many sites but for some types of ground
special pegs will be needed. Ask your dealer.
• Drive the pegs at a 45° angle away from the awning into
the ground.
• Peg the guy lines in line with the seam it starts from.
EN
Keep the following tips in mind while setting up the awning:
• The figures provide a general overview of the set-up. The actual set-up
will vary slightly based on the model of awning.
• Get help. The set-up is easier with more people.
• After standing the awning upright, check the corner pegs and re-peg
if necessary. The groundsheet on the inside should be taut and in a
rectangular shape.
• Peg the guy lines so that the awning is under tension without distorting
the shape.
• If available, attach the storm straps.
• Check the guy lines from time to time to ensure adequate tension, if
necessary use the runners to adjust.
Set up the awning as follows:
1. To protect the awning from dirt and damage, lay down a ground-
sheet or footprint before unpacking.
2. Unpack the awning.
3. Separate and identify the different components.
4. Proceed as shown to set up the awning (fig. 3, page 5 to fig. l,
page 8).
Only Ace AIR PRO500:
5. Inflate the additional air pole.
6. Fix the inflated air pole into place in the middle back roof panel using
the velcro fasteners.
Dismantling the awning
A
NOTICE! Material damage
Do not use force when dismantling the awning. Otherwise
you might damage any material.
1. Remove any dirt on the outside.
2. Close all window blinds or remove curtains.
3. Close all doors and openings.
4. If installed, push the canopy pole out of the sleeve, do not pull.
5. Remove all lines and straps.
6. Remove all pegs between the corner pegs.
7. Open the valves on each pole.
8. Wait until most of the air has been expelled.
9. Remove the four corner pegs.
10. Fold/roll the awning towards the valves to expel more air.
11. When deflated, roll the awning to fit into the carry bag.
12. Ensure that all parts are clean before packing the into the carry bag.
13. If the awning is wet or damp, dry fully as soon as possible.

Cleaning and maintenance

A
NOTICE! Material damage
• Do not use sharp or hard objects or cleaning agents for
cleaning.
• Do not use alcohol based materials, chemicals, soap
and detergents for cleaning.
• Remove bird droppings and tree resin as soon as
possible to avoid permanent damage to the material.
1. If necessary, clean the product with clean water and a soft brush.
2. Apply impregnation against water and UV radiation before each trip.
4445103255 11