Makita 3612 Manual De Instrucciones página 6

Ocultar thumbs Ver también para 3612:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
CAUTION:
Before operation, always make sure that the tool
body automatically rises to the upper limit and the
bit does not protrude from the tool base when the
lock lever is loosened.
Before operation, always make sure that the chip
deflector is installed properly.
1
Set the tool base on the workpiece to be cut without the
bit making any contact. Then turn the tool on and wait
until the bit attains full speed. Lower the tool body and
move the tool forward over the workpiece surface, keep-
ing the tool base flush and advancing smoothly until the
cutting is complete.
When doing edge cutting, the workpiece surface should
be on the left side of the bit in the feed direction.
1
2
3
1. Workpiece
3. View from the top of the
tool
NOTE:
Moving the tool forward too fast may cause a poor
quality of cut, or damage to the bit or motor. Moving
the tool forward too slowly may burn and mar the
cut. The proper feed rate will depend on the bit size,
the kind of workpiece and depth of cut. Before
beginning the cut on the actual workpiece, it is
advisable to make a sample cut on a piece of scrap
lumber. This will show exactly how the cut will look
as well as enable you to check dimensions.
When using the straight guide or the trimmer guide,
be sure to install it on the right side in the feed
direction. This will help to keep it flush with the side
of the workpiece.
003803
1. Chip deflector
2
4
4
2. Bit revolving direction
4. Feed direction
1
Straight guide (optional accessory)
The straight guide is effectively used for straight cuts
when chamfering or grooving.
Install the straight guide on the guide holder with the
wing bolt (B). Insert the guide holder into the holes in the
tool base and tighten the wing bolt (A). To adjust the dis-
tance between the bit and the straight guide, loosen the
001984
wing bolt (B) and turn the fine adjusting screw (1.5 mm or
about 1/16" per turn). At the desired distance, tighten the
wing bolt (B) to secure the straight guide in place.
1
2
3
4
Wider straight guide of desired dimensions may be made
by using the convenient holes in the guide to bolt on extra
pieces of wood.
1
55 mm
( 2-3/16" )
6
001985
2
3
4
003677
003683
5
003684
2
3
55 mm
( 2-3/16" )
1. Feed direction
2. Bit revolving
direction
3. Workpiece
4. Straight guide
1. Wing bolt (A)
2. Guide holder
3. Fine adjusting
screw
4. Wing bolt (B)
5. Straight guide
1. More than
15mm (5/8")
2. Straight guide
3. Wood

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

3612c

Tabla de contenido