Safety Regulations; Layout And Items Supplied - EINHELL TC-PO 110 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Important!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Caution!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
This appliance is not intended for use by persons
(including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
Safety information for polishing machines
Ensure that the polishing bonnet is securely
fastened to the polishing disk.
Do not touch any rotating parts!
Before you switch on, make sure that the poli-
shing disk is not blocked and can run without
any danger.
Always check the polishing bonnets and the
polishing disk for damage.
Replace torn or damaged polishing bonnets /
polishing disk immediately.
Do not switch on the polishing machine until
the polishing disk is resting on the surface
you want to polish.
Do not use any abrasives; these can destroy
the lacquer.
Harmful dust can develop during dry poli-
shing. Be sure to wear a suitable dust mask to
protect you from inhaling this dust.
Anl_SA_Anl_TC_PO_110_SPK8.indb 11
Anl_SA_Anl_TC_PO_110_SPK8.indb 11
GB

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Handle
2. Polishing disk
3. On/Off switch
4. Power cable
5. Textile polishing bonnet
6. Synthetic polishing bonnet
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
Open the packaging and take out the equip-
ment with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until
the end of the guarantee period.
Important!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
Polishing machine
Textile polishing bonnet
Synthetic polishing bonnet
Original operating instructions
Safety information
- 11 -
02.01.2018 07:55:55
02.01.2018 07:55:55

Publicidad

Tabla de contenido
loading

Tabla de contenido