Bosch TG502 Instrucciones De Funcionamiento Y Seguridad página 8

before making any assembly, adjustments
or changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
TUCKPOINTING
GUARD ASSEMBLY
moved. Retain Type 27 guard for future
use. Always reinstall Type 27 wheel guard
when converting back to grinding operations.
To improve ergonomics of your grinder when
cutting masonry, gearbox must be rotated rel-
ative to the position of the switch as the tool
was assembled at the factory.
Rotate gearbox (Fig. 2):
1. Unplug tool from power source.
2. Completely unscrew the four screws be-
tween the gear housing and motor body.
NOTE: Retain guard release lever with
spring for reassembling gear housing in
step 4.
3. Rotate gear housing to the proper orienta-
tion without removing motor from the hous-
ing.
a. For the slide switch models, rotate gear
housing 180 degrees in the direction in-
dicated in Fig. 3a, so the switch is 90 de-
grees from the spindle.
b. For the paddle switch models, rotate gear
housing 90 degrees in the direction indi-
cated in Fig. 3b, so the switch is facing the
work piece.
4. Screw in and tighten the three short screws
you removed.
5. The screw holding the quick release lever
is longer than the other screws, this long
screw must stay with the quick release le-
ver when re-attaching gear housing for the
quick release button to operate properly.
6. Attach proper dust collection guard with foot
and accessory.
REVERTING TO GRINDING APPLI-
CATIONS
Return gearbox to original position and re-
place Type 27 grinding guard. See manual for
grinder for details.
1600A003P6 08-14.indd 8
Assembly
Disconnect the plug
from the power source
The type 27 grinding
wheel guard must be re-
Fig. 2
4x
4x
4x
Fig. 3a
SLIDE
SWITCH
180
DEGREES
4x
4x
Fig. 3b
90
DEGREES
4x
8
m
0 m
m
0 m
SPRING
GUARD
RELEASE
LEVER
(x3)
m
0 m
180
DEGREES
PADDLE
SWITCH
UNDER
90
TOOL
DEGREES
8/13/14 2:22 PM