Connecting Emag 70 To A Television; What Is A Video Mode; Activating A Video Mode - Schweizer eMag 70 Manual De Instrucciones

Connecting eMag 70 to a Television

For greater magnifi cation, you can connect the unit to a television using the supplied video cable. To connect
your eMag 70 to a television, do the following:
1. Insert the yellow RCA plug that is on one end of the supplied video cable into the unit's TV connector port
as shown in the following illustration.
2. Insert the RCA plug on the video cable into one of your television's yellow video input connectors. Refer to
your television owner's manual for information on locating these connectors.
3. Turn on the television. If necessary, switch your television to the appropriate input channel. Items that you
magnify now appear on the television screen and the unit's LCD screen.
Plugging RCA plug into eMag 70
48
Using

What is a Video Mode?

A video mode is a pre-defi ned color combination (for example, yellow text on a blue background) which you
can select when viewing items with eMag 70 . The unit has a total of 23 different video modes. The fi rst three
video mode positions – Normal (full color), Black on White, and White on Black – cannot be changed and are
always available.Using the procedures in this section, you can activate and choose from a variety of 20 other
video modes. Once a video mode is activated (see Activating a Video Mode below), you can switch to it by
pressing the blue Color Select button .

Activating a Video Mode

By default, the eMag 70 has fi ve preconfi gured video modes that are ready for use. A video mode must be
activated before you can select it for use. To activate video modes, do the following:
1. Press and hold both the blue Color Select
8 seconds until you see a check mark or X in the lower left corner.
2. Push the blue Color Select button to cycle through all video modes until you fi nd the one
you want to activate.
Note: If a check mark appears next to the position number in the lower left corner of the screen, it
means that the video mode is active and can be selected during normal operation.
An X indicates that the video mode is inactive. During normal operation, you cannot switch to an
inactive mode when you press the Color Select button
and red Freeze Frame buttons for approximately
.
49