Sanyo ICR-NT300 Manual De Instrucciones página 6

Releasing Lock Function
Slide LOCK switch on rear side of the unit to OFF position to release Lock function.
Low Voltage Checking
The recorder will automatically check the voltage in every 30 seconds in non-recording status, or in every 5
seconds in recording status. When the voltage is lower, the Low Battery Indicator will display and the recording
function can't be played, which reminds you replacing the batteries.
If the recorder detects the voltage is lower in the recording status, It will terminate playing the recording function.
Resetting the Recorder
If your recorder is exposed to a strong static electrical charge, the recorder may lock up or the display may dim.
This rarely happens, but if it does, reset the recorder by removing batteries, and then re-installing the batteries.
All settings return to the preset values except the messages are kept without change.
Calendar and Time Setting
After batteries are installed, the display will indicate the time and year, month and date as 0 0- 0, the recorder
automatically enters time display mode, so that you can start to set your time.
. Press and hold STOP/MODE button 3 seconds to enter into set mode, then press STOP/MODE button three
times again, "SET DATE" will display.
2. Press PLAY/PAUSE button to enter into time and Calendar set mode. The digital of Year will flash. Press
REW or F.FWD button to set the Year, and then press PLAY/PAUSE button to confirm and go to Month
setting, the number of Month will flash.
3. Then set the Month, Date, Hour and Minute same as mentioned in point 3.
4. Press PLAY/PUASE Button to store your memory once completion of setting.
To Turn the Unit On
Besides clock functions, being a Recorder is the unit's major features. So it has 2 basic displays. One is
Time Display mode, and another is Digital Voice Recorder mode, under which the unit is ready for recording
operations.
To switch between Time Display mode and Digital Voice Recorder mode:
. In Time Display mode, press PLAY/PAUSE or REC/PAUSE button, the unit will enter into Digital Voice
Recorder mode. Press STOP/MODE for returning to Time Display mode.
2. The unit will automatically return to Time Display mode when no function key is pressed within 30 seconds.
Volume Control
In Digital Voice Recorder mode, press VOL+ or VOL- to adjust the volume to your comfortable level.
Selecting a Folder
This unit has 8 memory storage areas (file folders) to choose from, labeled 1 to 8. You can store a total of 200
messages or 920 minutes in normal mode (690 minutes in LQ mode, 270 minutes in HQ mode and 80 minutes
ICR_NT300_EN1.indd 4
operation
4
2008-3-28 16:17:06