Voice Activated Recording; Playing Back Messages - Sanyo ICR-NT300 Manual De Instrucciones

6. As well as normal recording mode, you can also use the HOLD REC mode by pressing REC/PAUSE button
for 3 seconds, the HOLD-REC signal will appear. To keep pressing REC/PAUSE button for commencing the
recording. To loosen the REC/PAUSE button for stopping recording.
In case of VOX function turns on in HOLD REC mode, the PAUSE signal and REC LED will flash when loosen
the REC/PAUSE button and the unit detects a pause of a few seconds. It will resume recording without keeping
pressing REC/PAUSE button, when the unit detects the sound. Press the STOP/MODE button to cancel the
HOLD REC mode.
• When you commence recording in the folder you selected, the recorder assigns a number to your recording
and displays the number on the display. The counter starts at . Each time you end a message and start a
new recording, the counter will increase, up to 27.
•
The "FULL" icon will flash when a folder is fully saved with 127 messages. Please go to next folder for the
continuation of recording.
•
When 200 messages have been fully saved or the total recording time has reached to maximum, the "FULL"
icon will also flash. Please delete some messages, if you need to continue the recording.
•
The built-in audio level control automatically sets the recording level.
• To record another message, press REC/STOP button. The message number increases one by one and the
new message is saved after any message you have already recorded.
•
For normal voice levels, a distance of 5 to 9 inches (13 to 22 cm) between the recorder and the recording
source (person speaking, for example) should be appropriate. To find the optimum distance between the
recording source and the recorder, please experiment with various distances.
Checking Message
You can check the message by pressing REW or F.FWD button in Digital Voice Recorder mode, the message
number and its recording time length will be shown on the display.
NOTE: Remaining time is the estimated time left for recording under current recording mode.

Voice Activated Recording

To set VOX on, switch the VOX button on rear side of the recorder to "ON" position and VOX icon will appear in
DVR mode.
Voice Activated Recording will allow dictation only when you speak. When the unit detects a pause of a few
seconds, it will temporarily stop recording until it detects sound again. If no sound is detected, PAUSE signal and
REC LED will flash.
NOTE: The built-in Automatic Level Control (ALC) automatically sets the recording level once recording starts.

Playing Back Messages

Your recorder has several options for playing back your messages. You can play the most recent messages and
go directly from playback to recording. You can also fast forward through messages or skip backward or skip
forward to get to the message you want to hear.
. Press PLAY/PAUSE or REC/PAUSE button to enter into Digital Voice Recorder mode from Time Displaying
mode.
2. Select a desired folder as described in "Selecting a Folder" (~8).
ICR_NT300_EN1.indd 6
6
2008-3-28 16:17:06