3. Temperature regulator (+)
4. Temperature display
5. Temperature regulator (-)
6. Shopping light
7. Shopping switch
8. Minidac light
9. Minidac switch
3.8 Switching on
1. Insert the plug into the wall socket.
2. Press the ON/OFF switch.
The Pilot Light will light up.
3.9 Switching off
To switch off the compartment press
ON / OFF. The Pilot light and the
Temperature display goes off.
3.10 Fridge Temperature
regulation
The temperature can be adjusted
between +2°C and +8°C.
1. Press the Temperature regulators (+)
or (-), temperature flashes on display.
2. To increase the temperature press
the Temperature regulator (+).
To decrease the temperature press
the Temperature regulator (-).
The temperature display shows set
temperature for a few seconds.
The compartment reaches
the selected temperature
within 24 hours
3.11 Shopping function
The maximum performance is obtained
by setting the Shopping function. It's
4. DAILY USE
WARNING!
Refer to Safety chapters.
4.1 Cleaning the interior
Before using the appliance for the first
time, the interior and all internal
accessories should be washed with
lukewarm water and some neutral soap
recommended when loading large
quantities of food.
You can activate the Shopping function
by pressing the Shopping switch.
The Shopping light will light up and the
fan automatically will start.
The internal temperature
goes down to +2°C.
After about 6 hours the
Shopping function switches
off automatically.
3.12 Temperature display
During normal operating the
Temperature display shows the
temperature inside the freezer / fridge.
The difference between
temperature on display and
set temperature appears
when:
• selecting new setting
• the door left open for a
long time
• after placing warm food in
the compartment.
3.13 Minidac function
You can activate the function by pressing
the Minidac switch.
The Minidac light comes on and the
function is activated.
The function can start
automatically if necessary,
refer to "Minidac".
to remove the typical smell of a brand-
new product, then dried thoroughly.
CAUTION!
Do not use detergents,
abrasive powders, chlorine
or oil-based cleaners as they
will damage the finish.
ENGLISH
7