Check Menu - MZ electronic EV030-Radio Instrucciones De Uso

Check menu

Use the (DOWN) or
LCD Test
This function switches on all the display's
pixels thus making it possible to perform a
check on them.
Software Version
Indicates the version of the software installed.
Work Hours
Indicates the hours of operation of the winch.
Exit
To return to the settings menu.
Instrument calibration
Before using the instrument the following parameters must be set:
•
choice of unit of measurement (metres or feet);
•
detection of type of sensor (Standard or Project);
•
gipsy diameter setting (default value 33 cm) or reduction factor (default value 57);
Standard and X.. Project series
sensor menu
Sensor Calibrat
Barb. Circ.
Divisor fact.
E xit
EV030-Radio
Tests
LCD Test
S w . V e r s i o n
W o r k H o u r s
E x i t
(UP) key to move around the parameters.
Select with
Confirm with
Confirm with
1000 – 1500 –2000 W Project series sensor
33.0
1
1 . 0 1
0
menu
Sensor Calibrat
Red. Factor
E x i t
28
English
5 7 . 0
Rev. 08 – 2019