Rear Panel Layout - VOX Amplification NIGHT TRAIN 15 Serie Manual De Usuario

3. BRIGHT CHANNEL Indictor – When using the BRIGHT channel, this is illuminated GREEN. When
using THICK mode, the indictor becomes ORANGE.
4. THICK Switch – When THICK mode is engaged, TONE controls are bypassed to give a big boost in
gain. This mode is foostwitchable using the optional VFS2A footswitch. Set to "THICK on" when using the
optional VFS2A footswitch. (NOTE: THICK mode only works on the BRIGHT channel. When this is on, the
tone controls aren't!)
5. GIRTH CHANNEL Indicator – When using the GIRTH channel, this is illuminated RED.
6. GIRTH GAIN Control – Use this to adjust the gain on the GIRTH channel. Crunchy Rock tones before
12 o'clock and searing Lead tones when fully cranked.
(NOTE: Because of the nature of the design of this amplifier, it may take a few minutes until the circuit
becomes stable after the power is turned on. Some noise might occur during this time but it soon
disappears.)
7. GIRTH VOLUME Control – Use this to control the overall level of the GIRTH channel, helping to balance
the outputs of both channels.
8. BRIGHT / GIRTH Channel Switch – Use this to change channel. This is footswitchable using the
optional VFS2A footswitch. Set Channel Switch to GIRTH when using the footswitch.
9. TREBLE Control – This controls the treble (high) frequencies in your sound - from soft and round when
turned down (counter-clockwise) to bright and cutting when cranked (clockwise) and all points in-between.
10. MIDDLE Control – This controls the middle (mid range) frequencies in your sound. From hollow when
turned down (counter-clockwise) to full and rich when cranked (clockwise) and all points in between.
11. BASS Control – This controls the bass (low) frequencies in your sound - from warm and light when turned
down (counter-clockwise) to dark and heavy when cranked (clockwise) and all points in between.
12. REVERB Control – Use this to add ambience to your tone, subtle when turned down (counter-clockwise)
and "surfy" when cranked (clockwise) and everywhere in between.
13. MASTER VOLUME Control – Use this to control the overall level of the amplifier, whilst retaining all the
tonal characteristics.
14. DARK Switch - Use this to tame the higher frequencies, giving the Amplifier a whole different character.
15. STANDBY Switch – Puts the Amplifier into STANDBY Mode. Meaning no output, just nicely warmed Tubes.
16. MAINS Switch – Turns the Amplifier On or Off!
17. MAINS Indicator – Shows whether your Amplifier is On or Off.

REAR PANEL LAYOUT

1. FX SEND Jack – Connect this to the input of your effect. (NOTE: This is a series effects loop).
2. FX RETURN Jack – Connect this to the output of you effect.
3. FOOTSWITCH Jack – Connect the optional VFS2A footswitch here, allowing for hands free control of
mode and channel switching.
4. 16 OHM Speaker Jack – Use this to connect the Night Train to any 16 ohm Cabinet.
4