Loewe Wireless Rear Sound Instrucciones De Montaje página 16

9
10
11
12
16
Transmitter module, preparing the back
of the housing
1. Sticking on the rear of the unit
Notes for sticking
The surface to stick to must be free from dust and
grease and must be dry. Room temperature (approx.
20 °C) is recommended for sticking.
Take the enclosed adhesive piece.
Pull off the protective foil on the side of the adhesive piece, fi g.
11.
Stick the piece to the back of the unit housing
Then pull off the 2nd protective foil and stick the unit housing in
the desired place.
2. Screw on the rear of the module housing
Remove the stoppers in the screw holes with a suitable tool (e.g.
hammer) (only necessary for wall mounting with screws)
The holes are now free and the half shell of the transmitter mo-
dule looks like the one opposite, fi g. 12.
Feed in the necessary cables before mounting on the wall.
You can fasten the half shell with suitable fastening material.
Suggestion:
With suitable screws (e.g. 3.5 x 15) on a wooden wall section.
With suitable screws and plugs (e.g. 6 x 30mm) on a masonry
wall.