Safety Instructions - Sinmag Europe Basic 5L Manual Del Usuario

ENG

2. SAFETY INSTRUCTIONS

Do not use the device when the head is lifted.
*
To avoid electric shocks, do not use this device in the vicinity of wa-
*
ter. Do not immerse the mains lead in water or other liquids.
Please read through the information and safety advice contained in
*
these operating instructions carefully and thoroughly before you use
the stand mixer for the first time.
Do not kink or clamp the mains lead. To avoid any risk of stumbling
*
or damage to the machine, do not allow the mains lead to hang over
the edge of a table or a counter.
Make sure that the voltage shown on the rating plate corresponds with
*
that of the mains supply. The rating plate can be found on the bottom of
the motor block. The stand mixer is only to be connected to an AC sup-
ply (~). The motor must always be switched off before the stand mixer is
connected with the mains supply (switch 5 in the "0" setting)
Do not use outdoors. The device is only suitable for using indoors.
*
The device should not be set up in close proximity to a naked flame,
*
inflammable materials (curtains, textiles, etc.), a radiator, an oven or
some other heat source.
Before use, place the device on a horizontal and flat surface.
*
Place this device as close as possible to the power source in order
*
that you can disconnect the plug quickly and easily.
The device must be operated with the type of power specified on the
*
rating plate. If you are unsure about the details of the available power
supply, ask your dealer or the local power supply company.
Do not attempt to repair the device yourself, since you will be expo-
*
sed to hazardous live components or other hazards by opening and
removing the covers.
4
SINMAG EUROPE BVBA