Electrical Connection - Sinmag Europe LAMINATO Manual Del Usuario

Check equipment and parts for damage. Report any damage immediately to the carrier
and dealer. Never attempt to operate the machine with damaged parts.
Report any deficiencies to the dealer that supplied the machine.
3.4 Location
1.
Select a location for the machine with a minimum of 0.6m space around the machine
for operating, cleaning and servicing.
2.
Position the machine in its proper working position. The machine must be installed
on a flat, solid and dry floor.
3.
It is recommended that the machine is level from front to back and from side to side.
This will ensure the greatest stability.

3.5 Electrical connection

1. An electrical supply should be available within the reach of the included power cord.
Do not use extensions to connect the machine's power cord to the electrical supply.
2. Before making the electrical connections, read the specifications on the rating plate
to ensure that they comply with those of the electrical supply. Electrical connection
should be made by a qualified service technician who will observe all applicable
safety codes and the national electrical codes.
3.
Check the correct connection (rotation) of the machine. If connected wrong, the
motor will run, but the knives will not move. If necessary, you will have to exchange
the position of 2 phase wires.
When connecting this machine to the mains supply, ensure that the following is carried out:
1. An isolating switch is fitted within 2m of the machine.
2.
A grommet/gland is fitted around the power supply cord entry hole into the machine.
3. All wiring connections must be checked and tight.
Once the electrical connection has been made, the machine is ready for use.
ELECTRICAL SUPPLY REQUIREMENTS 220/380V 3Ph 50/60Hz
SINMAG EUROPE BVBA
ENG
5