Chapter 5 - Installation Of Tecarpuls; Location Of Tecarpuls; Connection - SportTec 27535 Manual De Instrucciones

CHAPTER 5 - INSTALLATION OF TECARPULS

5.1

Location of Tecarpuls

•
Place the device on a firm, flat and stable surface
•
Do not use the device near a heat source, e.g. heat radiator
•
Avoid direct sunlight, rain, dust accumulation, moisture, mechanical vibration and hard
mechanical shock
•
Make sure that water and moisture do not enter the device (if necessary, cover the
equipment with a waterproof plastic). Should water still come into the device itself, unplug
the device (if connected) and contact Enraf-Nonius B.V. immediately
5.2

Connection

•
Main electric power supply must comply with national requirements for approved
electrical installations
•
Place the Tecarpuls so that it is easy to reach the ON / OFF switch on the back of the unit
•
Before connecting this device to the power supply, check that the voltage and frequency
specified on the rating plate on the back of the device match the intended power supply
Only the manufacturer's approved power cable must be used.
Only the manufacturer's approved electrode cable must be used.
Only the manufacturer's approved part defined as the floating earth
electrode and the treatment electrode must be used.
NB! Connection of optional equipment not specified by Enraf-Nonius B.V. can
endanger the patient and cause the device to malfunction.
IMPORTANT INFORMATION
9 of 32 EN109-1730752-41