BABYTREND nexgen Manual De Instrucciones página 8

OPERATION
TO REATTACH SEAT PAD
NOTE: Certain High Chair models are
packaged with the High Chair Seat Pad
and Seat Insert already attached to the
Seat Back.
19) • Thread non-buckle end of Harness
Straps called Harness Attachment
Tabs through the provided slots in
the Seat Fabric, Seat Insert, Seat
Back, and Seat Base (Fig. 19). When
Harness Attachment Tabs are through
the provided slots, rotate the Harness
Attachment Tabs 90 degrees. Make sure
that the straps are firmly in place.
20) • Loop the flap on the back of the pad
over the top of the Seat Back. Connect
the Seat Pad to the Seat Back with the
two Elastic Loops. These fit over the
Attachment Tabs located near the top
harness slots (Fig. 20a).
• Insert the Harness Covers through the
Harness Straps (Fig. 20b).
21) • Attach the bottom of Seat Pad to the
Seat Base with the two Elastic loops
located at the rear of the bottom of the
Seat Pad. These fit over the Attachment
Tabs located on the Seat Base near
where the Seat Back and Seat Base
Join (Fig. 21a).
• Attach each anchor hook of the Seat
Pad to the side of the seat armrest
(Fig. 21b).
• Ensure that the slot of the anchor hook
slides through the under side
division (Fig. 21c).
13
Copyright © 2020, Baby Trend ® Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
TO REMOVE SEAT PAD
Reverse the previous steps.
optional Seat Insert
22)
Fig. 19
Fig. 20a
Fig. 20b
• Set Seat Insert onto Seat Pad. See step
19.
Fig. 21a
Fig. 21c
Copyright © 2020, Baby Trend ® Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
OPERATION
Fig. 21b
Fig. 22
14