Maintenance - Dexter 20VMT2-20.1 Manual De Instrucciones

FR FR
5. OPERATION
ES ES
AFTER USE
PT PT
1. Switch the product off, wait for complete stop, disconnect the battery pack, let it cool down and
IT IT
remove the blade etc.
2. Detach the tool attachments from the product.
3. Check, clean and store the product as described below.
EL EL
PL PL

6. MAINTENANCE

RU RU
UA KZ
KZ UA
1. Remove the battery from the power tool before carrying out work on the power tool (e.g.
RO
RO
maintenance, changing tool, etc.). The battery should also be removed for transport and
storage. There is risk of injury from unintentionally pressing the on/off switch.
2. To ensure safe and efficient operation, always keep the power tool and the ventilation slots
BR
BR
clean.
3. Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
EN
EN
4. If the power tool becomes very dirty, this can lead to serious faults. Remove stubborn dirt with
high pressure air (max. 3 bar).
5. Check for worn or damaged parts. Replace worn parts as necessary or contact an authorised
service centre for repair before using the product again.
Do not use chemical, alkaline, abrasive or other aggressive or disinfectants to clean this product as
they might be harmful surfaces.
316
WARNING! Always switch the product off, disconnect the product from the power supply
and let the product cool down before performing inspection, maintenance and cleaning
work!
Only perform care and maintenance work according to these instructions! All further
works must be performed by a qualified specialist!