Installing The Electrical Kit - Westfalia 306 240 300 107 Instrucciones De Montaje

Installing the electrical kit

1. Disconnect the negative battery terminal.
2. Remove the spare wheel.
3. If necessary, remove the following coverings and panels:
•
In the luggage trunk
Covering of luggage trunk bottom
-
Covering of the rear end plate
-
Right-hand and left-hand side covering
-
4. Drill a hole of 40 mm for the cable leadthrough (Fig. 1/7) through the rear end plate on the
left-hand side of the spare wheel well in a suitable flat place.
5. Starting in the luggage trunk, lead the socket end of the cable harness through the cable
leadthrough to the outside and from there to the socket holder plate (Fig. 1/6).
6. Insert the rubber grommet into the cable leadthrough (Fig. 1/7).
Socket installation
7. Press the contact insert into the socket housing and push the rubber grommet towards the
socket.
8. Screw the socket onto the socket holder plate (Fig. 1/6) using the supplied screws and nuts.
Connecting the tail lights
9. Lead the cable end with the "left" marking to the left-hand tail light (Fig. 1/1).
10. Disconnect the plug-in connector of the left tail light (Fig. 1/1) and connect it to the matching
counterparts on the cable harness. Make sure that the plugs lock firmly into place.
11. Lay the cable end with the "right" marking along the rear end plate to the right-hand tail light
(Fig. 1/9).
12. Disconnect the plug-in connector of the right-hand tail light (Fig. 1/9) and connect it to the
matching counterparts on the cable harness. Make sure that the plugs lock firmly into place.
13. Connect the brown wires with the eyelet to the vehicle's ground point (Fig. 1/4).
12 306 240 391 101 - 002 - 48/04
Installation instructions:
Electrical system for towing hitch
Fiat Idea / Lancia Musa