Tabla de contenido
Publicidad
DESCRIPTION
The paso
MC102
a balanced signal in order to enable long-distance connections between the
microphone and the amplifying system. This microphone is characterized by a
clear voice reproduction,
conferences, newscasting, recordings and religious ceremonies. Two holes are
provided in the base of the microphone for wall mounting, which is particularly
suitable for access control applications and for counters for the public. The
hemi-cardioid polar diagram characterises the directivity of the microphone,
which reproduces sounds originating from the front end, within an angle of 60°
to the top on which it is placed, and suppresses background noise outside the
directivity curve.
The high-mass metal structure, suspended on special rubber feet, tends to
eliminate noise of vibrations induced on the surface on which it is resting.
CONNECTIONS
It is possible to connect the
capable of providing a phantom power supply. Proceed as follows:
1)
Make sure that the equipment is switched off.
2)
Connect the cable ending in a socket (mini
of the microphone.
3) Connect the three-pole
mixer of amplifier.
4) A led, in middle of microphone body, confirms the presence of phantom
supply.
NOTES CONCERNING USE
To exploit
totally
and stable surface, such as a tabletop or the floor. If it is to be wall-mounted, it
is possible to use the two holes on the base of the microphone (see Figure 1).
The holes are protected by a self-adhesive label that should be either removed
or holed only if the holes are to be used. Do not position the microphone in the
vicinity of heat sources or on amplifying equipment and avoid exposure to
high temperatures and high levels of humidity. Avoid contact with water.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL
!
OF THE PRODUCT IN ACCORDANCE WITH EC
will enable the constituent materials to be recovered, with significant
savings in energy and resources. As a reminder of the need to
dispose of this equipment separately, the product is marked with a
crossed-out wheeled dustbin.
microphone operates with phantom power supply and uses
therefore
XLR
the characteristics of the microphone, position it on a flat
DIRECTIVE 2002/96/EC
This product must not be disposed of as urban waste at
the end of its working life. It must be taken to a special
waste collection centre licensed by the local authorities
or to a dealer providing this service. Separate disposal
of electric and/or electronic equipment (WEEE) will avoid
possible negative consequences for the environment
and for health resulting from inappropriate disposal, and
EN
is used as a table-top microphone for
MC102
microphone to any Paso equipment
socket to the balanced microphone input of a
MC102, MC102-N
XLR
) to the plug on the body
Publicidad
Tabla de contenido
