Joerns Hoyer Advance Manual De Instrucciones página 17

English
*THESE CHECKS SHOULD INCLUDE:
ü = Required
* 6 months in North America
1. SPREADER BAR: Check the spreader bar for freedom of rotation and
swing. Check for wear on the central pivot. Check for firm attachment to
the boom.
2. BOOM: Check the attachment of the boom to the mast. Make sure there
is only minimal side movement of the boom and the boom is free to rotate
on the boom bearing.
3. MAST: Check the operation of the mast-locking device. Make sure the
mast fully engages into the socket. Check the bottom actuator or hydraulic
unit mounting.
4. ACTUATOR: (electric only): The actuator should require no maintenance
other than checking for correct operation and listening for unusual noise.
5. CONTROL BOX (electric only): Check the function of the emergency stop
button. Inspect the hand control socket for correct fitting. Check functioning
of the hand control. Check the redundant controls and confirm they operate
as intended. Note: The MINIMUM load required to manually lower the hoist
using the emergency lower function is 30 kg.
6. BATTERIES: (electric only): The batteries are housed in the power pack
and should not require maintenance other than the regular charging as
detailed in the charging instructions. Check that the connections remain clean.
7. HYDRAULIC UNIT: The hydraulic unit should require no maintenance other
than checking for correct operation and leakage of hydraulic fluid.
8. LEG ADJUSTMENT: Check the legs operate in both full extensions
(inward/outward).
9. CASTERS: Check all casters for firm attachment to the legs. Check for
free rotation of the caster and the wheels.
10. CLEANING: Clean with ordinary soap and water and/or any hard surface
disinfectant. Harsh chemical cleaners or abrasives should be avoided as
these may damage the surface finish of the lift. Avoid wetting any of the
electrical parts.
11. LOAD TEST: The load test should be carried out in accordance with the
manufacturer's test procedures.
12. BASE AND WHEELS: Ensure base is even and level
(all four wheels are on the floor).
13. SLINGS: Check for wear and fraying.
14. LUBRICATION: Oil pivot joints, including mast and boom connections,
pedal assembly, spreader bar joint (only if required).
15. FIXINGS: Check all nuts, bolts, screws and fasteners for excessive wear
and for tightness. Replace as required.
X = Recommended
Hoyer
®
Advance
ü ü ü
ü ü ü
ü ü ü
X
ü
ü ü ü
ü
ü ü
ü ü ü
ü ü ü
X
ü
X
ü ü ü
ü ü ü
ü
ü
17