Trimming The Locks For Several Doors; Horizontal Mortising; Corrections For Overlapping Doors - Virutex FC116U Manual De Instrucciones

U1
A1
X
J
Q
P
F
A2
S1
T1
A1
B1
X
F
A2
S
R

14. TRIMMING THE LOCKS FOR SEVERAL DOORS

To do this, having determined the height of the lock on the first
door, and placed the machine in the trimming position, mount the
has its limit at the upper edge of the door, and then fix the height
upper edge of the door, fix the clamp vises in this position and
so that all the locks remain at the same height.
to the floor.

15. HORIZONTAL MORTISING

doors before hanging them, it is advisable to disconnect the dam-
its pressure.
nally, adjust the length of the mortising required, as described in
section 9, before starting work with the machine, as it must never
operate at the end of stroke, over the maximum length.

16. CORRECTIONS FOR OVERLAPPING DOORS

For mortise trimming of doors with overlap, the centring of the
machine and the depth of the edge trimming should be changed,
as follows:
Check that the trimmer is disconnected from the
mains.
in this position.
the lock, plus the height of the door overlap, since the machine
will be supported on this overlap.
FC116U / Operating instructions - 25
-