Using Your Steam Mop - Shark S2901EU Manual De Usuario

Using Your Steam Mop

IMPORTANT: Make sure you do not use the mop
without attaching a cleaning pocket and adding
water to the tank first. When you are using the
mop for the first time, it might take longer than the
normal 30 seconds to start steaming.
1
Turn the water tank cap counter clockwise and
remove from the tank. (fig. 3)
2
Use the filling flask and pour water into the tank. Do
not overfill. Replace the cap on the water tank.
(fig. 4)
IMPORTANT: Do not use on unsealed wood or
unglazed ceramic floors. On surfaces that have been
treated with wax or some no wax floors, the sheen
may be removed by the heat and steam action. It
is always recommended to test an isolated area
of the surface to be cleaned before proceeding.
We recommend that you check the use and care
instructions from the floor manufacturer.
40
fig. 3
fig. 4
3
4
5
NOTE: To prolong the life of your Steam Mop, we
recommend using distilled water.
NOTE: Sweep or vacuum your floors prior to cleaning
with your Steam Mop.
Pull and twist the quick release cord holder to
unwrap the power cord completely. Plug into an
electrical outlet. (fig. 5)
Press the power button to turn the unit on. (fig. 6)
Clean your floors with a forward and backward
motion.
fig. 5
fig. 6