Sanit INEO SCOP Instrucciones De Uso página 15

ENGLISH
EN
Setting
Settings via the bidirectional maintenance and service remote control DO-5.1 S
Main flush
trigger
Start button and
operating button
Parameter Default setting
Short
range
0.5 m
range
0.8 m
range
Welcome
range
Light mode
Time lit
Colour
Brightness
Auto flushing
Timed scan
Intermittent
flushing
Stop time
Data recording
Setting ranges
15
(~ 5 cm) (~ 3 - 9 cm)
15
(~ 50 cm) (~ 40 cm -74 cm)
15
(~ 80 cm) (~ 40 cm - 150 cm)
15
(~ 140 cm) (~ 40 cm - 150 cm)
Welcome
Welcome
Light OFF
2 sec.
Red / green / blue /
green-yellow /
Blue
magenta / azure /
cold white
High Low / medium / high Brightness of the flush panel light
On OFF / ON
7 sec. 1 - 83 sec.
Off / 1 / 3 / 6 / 12 /
Off 24 / 48 / 72 / 96 /
108 hours
3 min. 1 - 10 min.
Function
11 - 22 Range for contactless manual triggering of partial and
full flush
Range for detecting automatic flushing. The person
12 - 48
must remain within this range for at least 7 sec.
Time can be changed under "timed scan".
Range for triggering an automatic full flush. If the
person remains within the 0.5 m detection range for
7 sec. and then leaves the 0.8 m range, the toilet will
2 - 38
flush automatically after 2 sec.
If a person remains within this range for longer than
2 min. and is not detected by the 0.5 m range, the flush
button goes out and no automatic flushing takes place.
- 18 to 18
Range for presence detection
Three different settings are possible.
Welcome Flush panel is switched on and
off via sensor
Light ON
- Light ON, flush panel is permanently lit
- Light OFF, flush panel is only lit during manual and
automatic triggering of the flushing function
Time the flush panel is lit after use
Light colour of the flush panel
Automatic flushing if no button is selected after use.
The automatic flushing function is only activated if the
user is within the 0.5 m within the set time window.
A full flush is triggered automatically after the last use
in the set time.
The stop time for deactivation of the flush panel for
cleaning and maintenance work can be changed.
15
Stop flushing
for 3 minutes
Send saved data
to other units