Sanit INEO SCOP Instrucciones De Uso página 18

ENGLISH
EN
10 sec.
Welcome
ON
OFF
OFF
ON
Activate the menu for the setting
Place your hands about 4 cm in front of both flush buttons
for 10 seconds until the flush panel lights up GREEN on
the left and flashes on the right. Now move your hands
away and follow the different settings II to V.
II Light mode
In the settings menu, cover the left-hand button briefly
until the flush panel lights up GREEN on the left. The
flush panel indicates the light mode set by flashing on the
right-hand side.
- flashes once
- flashes twice
- flashes three times = OFF
The mode is changed by briefly covering the right-hand
sensor and is then indicated by flashing.
When you leave the detection range, the required setting
is applied, the flush panel is ready for operation again.
III Automatic flushing
In the settings menu, cover the left-hand button briefly
until the flush panel lights up WHITE on the left. The flush
panel indicates the "automatic flushing" mode set by
flashing on the right-hand side.
- flashes once = function OFF
- flashes twice = function ON
The mode is changed by briefly covering the right-hand
sensor and is then indicated by flashing. The setting is
applied when you leave the detection range.
18
= Welcome
= ON