Default Setting - Sanit INEO SCOP Instrucciones De Uso

ENGLISH
EN
15 sec.
IV Choose light colour
In the settings menu, cover the left-hand button briefly
until the flush panel flashes slowly in the preset colour.
Use your hand to cover the right-hand button briefly, the
whole flush panel will light up in the next colour. Repeat
the procedure until the panel lights up in the colour you
require.
When you leave the detection range, the panel will flash
in the required colour as confirmation. The required colour
is now stored and the flush panel is ready for operation.
V

Default setting

In the settings menu, cover the left-hand button briefly
until the flush panel lights up MAGENTA on the left and
flashes on the right. The function II, III, IV is reset to the
default setting by covering the right-hand button briefly.
VI Detection range long range
Automatic range regulation
Place your hands about 4 cm in front of both flush buttons
for approx. 15 seconds until the flush panel lights up RED
on the right and left alternately.
Now move away from the flush panel to choose the max.
detection range.
Note: Doors which project into the detection range when
opened must be closed immediately after activation
(e.g. toilet cabins).
Wait for at lest 15 seconds, the flush panel is ready for
operation again.
15 sec.
19