Electronic Knife Assembly Procedure; End Of The Day Cleaning; Extended Periods Of Disuse; Troubleshooting. Recycling - Fimar MPF1,5 Manual De Uso

Electronic knife assembly procedure

To correctly assemble the
electronic knife, insert the
cutting unit in the support
shaft housing, rotate the
knife in front of the
expulsion area and
secure the fastening
lever.

End of the day cleaning

•
At the end of the day, remove the plug from the electrical socket and accurately clean the machine using
neutral detergents, paying careful attention to clean the lid, basin, mixer, screw, nozzle and knife while
the dough is still soft.
•
Nozzles should be stored under water until futher use to prevent any remaining dough to dry and clog
holes. For correct basin cleaning, unscrew and remove the kneading hook and expulsion screw.
•
Clean outer machine parts with a damp sponge. Do not use metallic pads and abrasive detergents.

Extended periods of disuse

For extended periods of disuse, turn off the main wall switch, clean the machine and cover it with a cloth
to protect if from dust.

Introduction

In the event of breakdown or malfunctioning, turn off the wall fuse and contact your Dealer's service centre.
Avoid dismantling internal machine parts.
The manufacturer is not liable for any machine tampering!

Problems, causes, solutions

Problem
The machine does not start

Disposal and recycling

The machine was designed and constructed to work for an average of 10.000 hours. When finished using
the machine, follow national laws for disposal and recycling.
Please contact the environmental authorities or authorised organisations.
TROUBLE SHOOTING,
Cause
Main switch off
No voltage on the power supply
Safety fuse burnt out
11
Connect the cutting unit
motor by inserting the
jack
machine socket.
RECYCLING
Solution
Turn on main switch to "I"
Contact your dealer's service centre
Contact your dealer's service centre
in the specific
4