Electrical Connection; Appliance Description - Beem B21.001 Manual De Instrucciones

EN

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions must
be observed for the electrical connection:
■ Before connecting the appliance,
compare the connection data (voltage
and frequency) on the rating plate with
those of your mains power supply. The
data must correspond in order to avoid
damage to the appliance. If in doubt,
ask your electrical appliance retailer.
■ The mains socket must be protected
by at least a 10 A automatic circuit
breaker.
■ Ensure that the mains lead is undam-
aged and is not laid over sharp edges.
■ The mains cable must not be pulled
tightly, bent or come into contact with
hot surfaces.
■ Route the cable to prevent risk of trip-
ping.
■ If the appliance is to be connected
to the power supply via an extension
lead, the cable cross-section must be
at least 1.5 mm².
■ The electrical safety of the appliance
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. Connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualified
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.
BEEM - Elements of Lifestyle
Aroma Grill-Express

Appliance description

(see illustration on the left fold-out)
1 Lid
2 Control indicator
3 Thermostat
4 Drip tray
5 Cleaning spatula
6 Handle
7 Lower grill plate
8 Aroma depot
9 Upper grill plate
10 Aroma depot lid
11 User manual (not illustrated)
Thermostat
Proceed as follows to set the temperature:
Turn the thermostat (3) to set the de-
‹
sired temperature:
Level Meaning
The grill plates are turned
0
off.
Setting the temperature:
1 - 3 1: low temperature
3: highest temperature
19