EMAK TT-C Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 9
TT-C walk-behind saw trolley
1. Safety precautions
Use this walk-behind saw trolley only with Emak cut-off saws of the type 963TT-
A - 983TT-A - TT163 - TT 183 - HS 63 - HS 81A.
Observe the instructions and safety precautions listed in the operating instruc-
tions for your Emak cut-off saw.
2. Assembling the walk-behind saw trolley
2.1 Fitting the wheels
1
2
1.Fit the wheel
, washers
and split pins
2.Expand the split pins
.
2.2 Fitting the axle and wheel
3
1.Fit the axle
and tighten the clamping screws.
2.Fit the second wheel
(see 2.1).
2.3 Fitting the cutting depth adjustment arm
1.Fit the cutting depth adjustment arm
with washer and the mounting screw
2.Tighten the mounting screw
2.4 Fitting the grip
7
8
1.Fit the grip
using the clamping screw
2.Tighten the clamping screw
2.5 Fitting the water tank
9
10
1.Pivot the tank support
upwards and then tighten the clamping screw
securely.
2.Position the tank
on the support and push it downwards until it engages.
3. Fitting the water supply
3.1 Fitting the water nozzle
11
1.Fit the water nozzle
.
2.Fit the hose clip
.
3.2 Fitting the hose
13
14
1.Tighten the hose clip
.
2.Use a cable tie
to secure the hose
2
onto the wheel axle
4
5
6
) using the clamping lever
with washer and lockwasher.
and clamping lever
.
and washer.
securely.
12
.
4. Mounting the cut-off saw
4.1 Opening the clamp
1.Open the grip clamp
2.Release the saw support axle clamp
4.2 Bringing the saw into position
1.Engage the saw support axle
2.Position the grip of the saw
4.3 Securing the saw
.
1.Close the grip clamp
2.Close the saw support axle clamp
4.4 Fitting and adjusting the throttle cable
1.Fit the throttle lever
2.Adjust the throttle cable
5. Service drawings
5.1 Wheel assembly and throttle cable service drawing
5.2 Water tank and grip service drawing
15
16
.
and slide it upwards.
17
18
in the saw mount, as shown.
on the grip clamp.
19
20
and tighten the screw to secure the grip
and tighten the clamping screw
21
22
and secure it in position.
until free from play and then tighten the locknut.
24
.
.
23

Publicidad

Tabla de contenido
loading

Tabla de contenido