Getting Started - TFA 30.5036 Instrucciones De Uso

TFA_No. 30.5036 Anleitung_07_19
KLIMA BEE - Thermo-Hygrometer
Caution!
Risk of injury:
• Keep this instrument and the battery out of the reach
of children.
• Batteries contain harmful acids and may be hazardous
if swallowed. If a battery is swallowed, this can lead to
serious internal burns and death within two hours. If
you suspect a battery could have been swallowed or
otherwise caught in the body, seek medical help
immediately.
• Batteries must not be thrown into a fire, short-circuit-
ed, taken apart or recharged. Risk of explosion!
• Low batteries should be changed as soon as possible
to prevent damage caused by leaking.
• Wear chemical-resistant protective gloves and safety
glasses when handling leaking batteries.
Important information on product safety!
• To avoid damages of the sensor on the board, do not
remove the black protective cover.
• Do not place your product near extreme temperatures,
vibrations or shocks.
• Protect it from moisture, sand, dirt and dust.
5. Elements
Buttons
ON/OFF button (front)
MAX/MIN button (laterally)
Housing (back)
Tripod screw
Battery compartment (screwed)
10
12.07.2019 7:21 Uhr
KLIMA BEE - Thermo-Hygrometer
6. Operation

6.1 Getting started

• Open the battery compartment and insert the new bat-
tery 9 V. Ensure that the battery polarity is correct.
• Please pay attention to the connection wires.
• Close the battery compartment again.
• All LCD segments will be displayed for about a few se-
conds.
• On the display appear the battery symbol, the actual
temperature (default: °C) and humidity.
• The unit is ready for use.
• The instrument will turn off automatically after 15
minutes, if no button is pressed.
• Press and hold the ON/OFF button for at least 3 sec-
onds to turn off the instrument immediately.
6.2 Measuring of the temperature and humidity and
HOLD function
• Press and hold the ON/OFF button.
• All LCD segments will be displayed for about a few se-
conds.
• On the display appear the battery symbol, the actual
temperature (default: °C) and humidity.
• Press the MAX/MIN button to activate the HOLD func-
tion.
• HOLD appears on the display.
• The actual temperature and humidity stay on the dis-
play.
• Press again the button, to deactivate the HOLD func-
tion.
6.3 Reading of the maximum and minimum values
• Press and hold the MAX/MIN button for at least 3 se-
conds to enter the maximum and minimum mode.
• MAX appears on the display.
Seite 6
11