Vertical Steam; Dry Ironing - SOLAC PV2020 Instrucciones De Uso

PV2020_2030.book Page 16 Thursday, July 19, 2007 6:45 PM

Vertical steam


It allows you to remove creases from delicate garments without having
to place them on the ironing board: jackets, overcoats, curtains, etc.
1 Fill the water tank as explained in the "Steam ironing" section.
2 Place the garment on a hanger, well away from other garments, people,
animals, etc.

Do not discharge steam onto a garment hanging in the wardrobe or on
a person.
3 Set the steam control (10) to the closed position and the temperature
selector (9) to the MAX position.
4 Bring the iron, in the vertical position, close to the garment (between 15
and 30 cm) and press the supersteam button (8) once only. Do not place
the iron too close to the garment as it could cause damage.
5 Wait a few seconds before pressing the button (8) again, so as not to
damage the garment. Most creases can be removed with three blasts of
steam.

Dry ironing

1 If there is water in the tank, turn the steam control (10) to the closed position
(Fig. 2), to prevent water from coming out.
2 Plug in the iron and set the temperature selector (9) to the desired
position. The pilot light (12) will go off when the temperature is reached.
Spray ironing

Spray can be obtained by pressing the corresponding button (7) when
dry ironing or ironing with steam. The temperature level does not matter.
• Press the spray button (7) as many times as you want to use this
function.
Emptying the water tank

When you finish ironing, always empty the water from the tank.
1 Place the steam selector (10) in the closed position (fig. 1).
2 Unplug the plug from the mains
3 Open the water filler opening (5) and place the iron face down over the
sink, gently shaking it to completely empty the tank.
4 Wait until the iron is completely cold and store it in the vertical position in
a secure place.
16 Use